STOMA JSC

Artificial plastic teeth Estedent-02 are designed for application in prosthodontics for manufacturing of remov­able denture constructions. Plastic teeth Estedent-02 are manufactured on base of cross-linked acrylic polymers. They have a fluorescent effect (teeth put into partial denture look harmoniously near natured teeth in ultra-violet rays). Teeth Estedent-02 have a good chemical binding with denture base. Like their natural prototype teeth Estedent- 02 have optimal functional and cosmetic characteristics. Teeth Estedent-02 are manufactured in accordance with “Vita” scale and consist of 9 shades: A2; A3; A3.5; B2; B3; C2; C3; D2; D3. Due coloring scale Estedent-03 teeth comply with colors № 28, 32, 33, 34, 35, 36, 38, 40, 41.

Indications for use: manufacturing of complete upper- and lower jaw dentures; manufacturing of partial dentures; Strong points: high accuracy shape reproduction; high ultimate flexural strength; optimal elasticity; beneficial cosmetic effect due to denture translucency and introduction of «streaks» that imitate the soft tissues of the oral cavity; good polishing ability; Application instructions: mix powder with liquid in 2:1 ratio; plastic modeling phase is about 20 minutes; carry out the polymerization process in a water bath in dental flasks, by bringing the water bath to boiling point gradually within 40-50 minutes; polymerization process takes 30 minutes; do not retrieve the denture from the flask until it is cooled down completely;

Indications for use: manufacturing of temporary plate-type removable dentures; repair and restoration of removable dentures; maxillofacial appliances; orthodontic appliances; manufacturing of removable prosthetic splints; Strong points: multipurpose use; rapid guaranteed polymerization; beneficial cosmetic effect due to denture translucency and introduction in material of "streaks" that imitate soft tissues of oral cavity; good workability of products; Application instructions: mix-up powder and liquid in a 2:1 ratio; carry out the process of polymerization at room temperature in a heating cabinet at 35-45°C for 25-30 minutes; treat and polish the material by conventional methods;

modeling of removable denture bases; manufacture of occlusion templates with occlusive to ruses; manufacture of individual spoons and base spoons; Strong points: material has high plasticity properties; material is easy to mold; when tooled, the material does not break or delaminate; material is easy to remove completely from plaster molds using boiling water;